Dtc 1260 on saab 9-3

images dtc 1260 on saab 9-3

Hi johnmartin, Here are the description of the problem. Restart diagnostic procedure. If test light does not operate as specified, check for faulty circuit between throttle body harness connector terminal No. Recheck for any stored DTCs. Drive vehicle for 5 minutes under varying loads and engine RPM.

  • UKSaabs • View topic 95 Aero fault code P throttle body
  • Saab 95 Fault Coe My Saab Keeps Showing Engine Management

  • Hello Forum my name is Billy I am new to the forum and I own a Saab Turbo, having a little problem and hope you guys can give me a. Code: P Throttle Return Spring Too Low Force.

    Workshop · Classic Saab & GM ( - )/Conv (); Error code P › UKS › viewtopic.
    If test light does not operate as specified, check for faulty circuit between throttle body harness connector terminal No.

    Im pretty handy, so if you explain it i'll probably be able to do it. Please login or register to post a reply.

    UKSaabs • View topic 95 Aero fault code P throttle body

    I have the same car and I am having the same fault code, although its not the same symptoms. Start engine and allow it to run until radiator fan turns on. Use scan tool to clear all system DTCs. Ensure that throttle is not obstructed and that throttle spring returns throttle valve completely until contacting stop screw.

    images dtc 1260 on saab 9-3
    PHAEDRA APOLLO ARRESTED ATLANTA
    NOTE : Problem may set if throttle mechanism is not reset after repairs.

    Check for faulty circuit between throttle body harness connector terminal No. Reset limp-home mechanism. It's Free! Turn ignition off. Here are the diagnostic procedures as outlined in the manual.

    Car Model: Saab Aero estate manual Carlsson.

    Saab 95 Fault Coe My Saab Keeps Showing Engine Management

    Because the throttle body is in limp mode, the P code will keep coming up. NG or old Only > code p throttle relearn??? I drove it a few miles and a code of p came up saying I have to do a throttle. › cars › tp_code.
    Recheck for any stored DTCs.

    Turn ignition on. If test light does not operate as specified, check for faulty circuit between throttle body harness connector terminal No. Disconnect throttle body electrical connector. Go to next step.

    images dtc 1260 on saab 9-3

    Reset limp-home mechanism.

    images dtc 1260 on saab 9-3
    Ta wan bandung shopping
    If throttle valve operation is not as specified, repair or replace throttle body as necessary.

    Video: Dtc 1260 on saab 9-3 SAAB 9-3 Production Sport S

    Reset limp-home mechanism. Repair as necessary. The test light should alternate between green and red. Wait 10 seconds, then open and close throttle by hand. Recheck for any stored DTCs. Use scan tool to clear all system DTCs.

    p code saab p code also traction control light came on that dtc is about trottle body,or the return spring is not good or the.

    Video: Dtc 1260 on saab 9-3 2007 Saab 9-3 2.0T O2 Sensor Replacement

    › Forum › Saab Workshop › Saab and (). Thread: OBD error codes P, P and P Navigation. Forum · Saab Workshop · Saab and () · Ov3rB00st's Avatar.
    NOTE : Problem may set if throttle mechanism is not reset after repairs. I Took It To If test light does not operate as specified, check for faulty circuit between throttle body harness connector terminal No.

    Go to step 3. Please login or register to post a reply.

    images dtc 1260 on saab 9-3
    Royal ballet contemporary songs
    Check for faulty circuit between throttle body harness connector terminal No. My saab keeps showing engine management light and sometimes traction control off light comes on and we go into limp home mode.

    Hi johnmartin, Here are the description of the problem.

    images dtc 1260 on saab 9-3

    The test light should alternate between green and red. I have the same car and I am having the same fault code, although its not the same symptoms.

    images dtc 1260 on saab 9-3

    4 Replies to “Dtc 1260 on saab 9-3”

    1. Recheck for any stored DTCs. Im pretty handy, so if you explain it i'll probably be able to do it.

    2. Im pretty handy, so if you explain it i'll probably be able to do it. Disconnect throttle body electrical connector.

    3. Drive vehicle for 5 minutes under varying loads and engine RPM. Here are the diagnostic procedures as outlined in the manual.